Yamaha Rio1608-D2 Dante Digital Mix Rack

Rental Quote Request

Contact Name *
Fill out this field
Contact Email *
Please enter a valid email address.
Contact Phone *
Fill out this field
Hire Start Date *
Fill out this field
Hire End Date *
Fill out this field
Message
Fill out this field
Are you a robot? What is 19 - 8 = ?
Enter the equation result to proceed

The Yamaha Rio1608-D2 presents high-performance I/O rack features with 16 analog inputs and 8 analog outputs, and is compatible with Yamaha CL and QL series audio consoles as well as the RIVAGE PM series.

The Rio1608-D2 connects directly to Dante digital audio networks, allowing flexible system configuration. Dual power supply units are built in for high reliability, and a character/graphic display offers easy visual confirmation.

Features

  • 16 analog inputs and 8 outputs.
  • Redundant DANTE connections are supported with primary and secondary connectors. Daisy chain connections are also supported.
  • Comprehensive display and local control of gain and other parameters.
  • Power consumption: 72W
  • Dimensions (WxHxD): 480 x 132 x 368mm (18.9″ x 5.2″ x 14.5″)
  • Net Weight: 9.6 kg (21.2 lbs)
Data Sheet Click here
Exernal Sampling frequency rate 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, +4.1667%, +0.1%, –0.1%, –4.0% (±200 ppm)
Signal Delay Less than 1.7 ms, Rio INPUT to Rio OUTPUT connect with PM10 using Dante, Fs= 96 kHz, Dante Receive Latency set to 0.25 msec
Total harmonic distortion Less than 0.05% 20 Hz-20 kHz@+4 dBu into 600Ω, Fs= 48 kHz, Less than 0.05% 20 Hz-40 kHz@+4 dBu into 600Ω, Fs= 96 kHz, INPUT to OUTPUT, Input Gain= Min.
Frequency response +0.5, –1.5 dB 20 Hz-20 kHz, refer to +4 dBu output @1 kHz, INPUT to OUTPUT, Fs= 48 kHz / +0.5, –1.5 dB 20 Hz-40 kHz, refer to +4 dBu output @1 kHz, INPUT to OUTPUT, Fs= 96 kHz
Dynamic range 112 dB typ., DA Converter, 108 dB typ., INPUT to OUTPUT, Input Gain= Min.
Hum & noise level – Equivalent input noise –128 dBu typ., Input Gain= Max.
Hum & noise level – Residual output noise –88 dBu, ST master off
Crosstalk -100dB, adjacent INPUT/OUTPUT channels, Input Gain = -6dB, @1 kHz *Measured with a 30dB/octave filter @22kHz
Power requirements 100-240V, 50/60Hz
Power consumption 72W
Dimensions W 480 mm (18.9″) x H 132 mm (5.2″) x D 368 mm (14.5″)
Net Weight 9.6 kg (21.2 lbs)
Others NC Value: FAN MODE LOW: NC=15 / HIGH: NC=25 (Measurement position: 1 m from the front of the unit), Operating temperature range: 0 – 40°C, Storage temperature range: –20 – 60°C
No results found.